Esu 51970 manual

Description. ESU I/O Expansion Board For 21 Pin LokSound LokPilot Decoders ~ 4 Aux. Active extender board containing a pulsed smoke generator (see separate listing), 4 Servo controllers, interface to ESU Power Pack and interface for 2 (wheel) magnetic or hall sensors. The smoke generator controller is syncronised to the sound of the loco.  · To activate ESU keys via phone, follow these steps: Open an elevated Command Prompt. Type www.doorway.ru /ipk ESU MAK Key and select Enter. to install the product key. Get the Installation ID for the ESU Key using the corresponding ESU Activation ID (see the table of ESU Activation IDs for each program listed earlier in the blog post). For example.  · ESU Owners Manual: Decoder Tester. If you have any questions or feedback regarding this advice, please feel free to contact us at salesuk@www.doorway.ru or via the enquiries form on our Contact Us page. Fullscreen Mode.

This is a pin (2x11) male header on 1,27 mm pin spacing to make a wired ZIMO P22 - Type decoder from a normal hardwired decoder, e.g. convert a MX to a wired MXP This connector conforms to NMRA RP Standard for Electrical Interface Connectors and the NEM Standard. Part No: PLUX Operational To use with ESU ECoS or Mrklin Central Station. modes Supported protocols (depends on command station): NMRA DCC, Motorola, Selectrix, M4 Dimensions x 76 x 40 mm ( x x inch) ECoSBoost with A continuous-load output, power supply 18V / 5A Included in (90VA), terminals for track- and programming connection. Page 25 in the manual indicates that AUX3 through AUX6 are still logic-level outputs, so ESU would still be NEM-compatible and not Märklin-compatible. Also see table on page There are some inconsistencies in the manual, so in case of doubt contact ESU for details. One example: AUX5/6 are missing in the diagram on page

Description. ESU I/O Expansion Board For 21 Pin LokSound LokPilot Decoders ~ 4 Aux. Active extender board containing a pulsed smoke generator (see separate listing), 4 Servo controllers, interface to ESU Power Pack and interface for 2 (wheel) magnetic or hall sensors. The smoke generator controller is syncronised to the sound of the loco. For the record, the LS V4 manual makes it clear in section that the 21 MTC version of the "ordinary" LS V4 has Logic level only outputs on Aux 3 and Aux 4, meaning that if you want to use them you have to use the adapter board, or I/O expansion board, or make up your own amplifier. With this expansion board you can easily expand your LokPilot V or LokSound V decoder (with 21MTC interface!). All you need to do is to plug the decoder onto the expansion board and benefit from using 4 additional function outputs (AUX5 through AUX8) for lighting effects, coupler etc. In addition, you are able to connect 2 RC-servos!.